ACOPOS 6D使用手册 > mapp 6D > 入门指南 > 开始使用 ACOPOS 6D<br/>

项目已准备就绪，可以开始构建。重新启动 CPU 后，可以在记录仪中检查系统启动是否正确。

由于引入时使用的是 X20 CPU，因此 ETH 接口必须配置静态 IP 地址或唯一主机名，以便在传输项目后能够连接到 PLC。

建议在初始安装时使用 CF 读卡器进行离线安装。

The project is prepared and can be built. After the CPU is restarted, you can check in the Logger whether the system was started correctly.

Since an X20 CPU is used for the introduction, the ETH interface must be configured with a static IP address or unique hostname in order to be able to connect to the PLC after transferring the project.

Offline installation with a CF card reader is recommended for the initial installation.